CAN Bus Frontend expansion board


 

USD5.95

10 days
BUS2S-CAN
97 item(s)
+

Description

For more details and documentation, see product page on old site.

The BUS2S-CAN is a CAN Bus Frontend expansion board. It is design to fit onto the Frontend connector of our MicroX range of boards. When connected to the Frontend port of a compatible MicroX SBC board it will add a CAN Bus interface to it. For a list of compatible SBC boards, see documentation on old site (link given above).

This board is used together with a Modtronix SBC board that is fitted with a CAN enabled PIC chip. Examples of compatible SBC boards with PIC chips are:

  • SBC28PC-IR2 fitted with the PIC18F258 chip.
  • SBC45EC fitted with PIC18F458 chip

It is supplied with a 5 pin 3.81mm screw type terminal block plug and a CAN Bus driver chip as show in the picture. The CAN Bus signals, ground and optionally (selected via straps) the positive supply are made available on a 5 pin 3.81mm terminal block connector. See the datasheet for details.

A 3mm red LED is connected to the Frontend connector signal B6. When plugged into a SBC board, this signal is routed to PIC port pin RB6. The user application running on the MicroX SBC board can control this LED via port pin RB6..

This product has been retired! Available as long as stock lasts. Do not use for new designs!

What is included

  • 1 x BUS2S-CAN Frontend Board, fully assembled (with MCP2551 driver chip with 15kV ESD protection).
  • 1 x 1 x 5 Pin 3.81mm Terminal Block Plug (TB05P-F381-R4)
None