Important! Note "Header Type" and "Power Connector" Options above for selecting pin header and power connector! See "Pin Headers" and "Order Code" sections below for details.
The pm35SS-5 is a Switch Mode Regulator power supply module(breakout board). It converts an input from 6V to 28V to a 5V output. It has a maximum output current of 1.5A. It contains a diode for polarity protection (3A, very low forward voltage diode).
Standard 2.54mm (0.1") pin headers are used. The pin header rows on either side of the module are spaced 0.7" apart, allowing the module to be used with standard breadboard or prototyping board.
This regulator uses a high quality switch mode regulator from TI (Texas Instruments).
A total of 7 capacitors (3 input and 4 output) are used to ensure a very smooth, high quality output voltage! Most standard regulators only use 2 capacitors. This superior design makes this regulator suitable for low noise applications like analog and RF circuits. A mixture of Ceramic and Aluminim capacitors with total value of 67.1uF are used for the output capacitors. A mixture of Ceramic and Aluminim capacitors ensures lower output noise! The voltage rating of all capacitors used are at least twice the required voltage, ensuring long capacitor life!
To use this module, simply provide a supply voltage of up to 28V on the "+" and "-" terminals of the power connector. The regulated output will be available on the "0V and "5V" pins. The polarity(diode) protected supply voltage is available on the "0V" and "Vx" pins (about 0.2 to 0.4V less than supply voltage).
This module is designed and manufactured by Modtronix! Only high quality components from reputable suppliers are used! This is NOT a cheap module using no-name components! See "High Quality Components" section below for component details.
This board is part of our iMod product range, and can very easily be added to any of our products that have iMod ports.
Schematics (pdf format)
|Click to enlarge|
The pm35ss-5 has two rows of standard 2.54mm (0.1") pin headers. The rows are 0.7" apart, allowing this module to be mounted on a breadboard or standard 0.1" grid prototype board. The picture to the right shows some iMod modules mounted on a standard prototype board.
The pin headers supplied or soldered to this board are selected in the "Header Type" option at the top of this page.
This module is designed and manufactured by Modtronix! Only high quality components from reputable suppliers are used! All components have been selected to exceed the maximum rated specifications. The following components are used:
|pm35ss-5 Datasheet and Schematics|
|Datasheet for LM25011 Regulator from TI|
The following order codes can be used to order this module with different terminal block options:
The following codes can be appended to the order codes shown above to add pin headers. See the "Pin Headers" section above for details:
For example, to order this board with a pluggable, 3.5mm terminal block connector, and press-fit headers assembled, use the following code:
To pay via PayPal Express Checkout, go to Cart! Paying via this method is very fast, no sign in or registration is required. Your address information at PayPal is used.