Prototype Board, Compact


 

USD10.00

10 days
PT66ECI
30 item(s)
+

The PT66ECI is a prototype board for Netcruzer SBC66 Single Board Computers. The SBC66 board is plugged onto the PT66ECI board as a daughter board. All the SBC66 board's signals are made available on the PT66ECI, and prototyping space is provided. It can be mounted in the ENC2015S-NZ or ENC2015S-BK-NZ enclosure, and matching enclosure face plates are available for different SBC66 boards. If the SBC66 board is required to be screwed in place, the PCBSP-143 14.3mm spacer can be placed between both boards, and boards can be screwed/bolted together. The SCREW-222SC440 self cutting screw can be used when mounting in a ENC2015S-NZ enclosure.


(Click to enlarge)
 

Features

  • Two 12-pin, 3.81mm terminal block connectors
  • Reset and Firmware button. If Firmware button is held in during reset (power on), board will enter bootloader mode. In this mode, firmware can be upgraded via the Netcruzer USB Bootloader. For details, click here.
  • One iMod port for adding iMod Module. For example, can add RS-232, RS-485, 1-Wire or other iMod modules.
  • Can be mounted in the ENC2015S-NZ enclosure

Adding Processor Board

The daughter board connector has been designed for mounting a Netcruzer SBC66 Single Board Computer. The pictures below show some examples of mounting SBC66 boards onto this prototype board.

Click to enlarge

Adding iMod Modules

This board has 1 iMod port for adding an iMod module. iMod modules can be added in a variety of different ways:

  • Soldered in place
  • Pressed in with press-fit connectors
  • Plugged in for prototyping

For more information iMod modules, click here.

Adding a RS-485 iMod module

Soldered iMod module

Plugged in iMod module

Click to enlarge

Enclosure

It can be mounted in the ENC2015S-NZ or ENC2015S-BK-NZ enclosures. Matching faceplates are available for different SBC66 processor boards. If the SBC66 board is required to be screwed in place, the PCBSP-143 14.3mm spacer can be placed between both boards, and boards can be screwed/bolted together. The SCREW-222SC440 self cutting screw can be used when mounting in a ENC2015S-NZ enclosure.

The pictures below show some examples of this board mounted in and enclosure.



Spacer and screw used to secure SBC board


Click to enlarge

Details and Documentation

For the user manual, including schematics, click here. PLEASE NOTE that this manual is for the Revision 1 board, which is not available any more. The current board is revision 2. I has better labels on the PCB, and some other minor changes. See pictures on this page for current revision 2 board.

Eagle Schematics and PCB

The schematics and PCB file can be downloaded here.

What is included

  • 1 x Fully assembled prototype board, as shown in the main product picture at the top of the page
None