PGM2KIT Programming Adapter for PICKit 3

Description

The PGM2KIT is used together with the PICKit 3, PICKit 4 or PICKit 5 to program and debug Netcruzer SBC boards. This adapter consists of 2 boards connected via a ribbon cable. The connector on the smaller board (PGM02) fits into the programming connector of any Netcruzer Single Board Computer (SBC, for example SBC66EC, SBC66UAL...).  The other end plugs into the PICKit.

To use this adapter, you must have a Microchip MPLAB PICKit 3 Debugger/Programmer (or PICKit 2). Clone devices that use the same pin-outs as the original Microchip device should also work, but have not been tested.

Without small PGM02 board

If the SBC board is used in such a way that there is no space to use this adapter in the standard way, it can also be used without the small PGM02 board as shown in the pictures to the right (click for larger picture).

(Click to enlarge)

(Click to enlarge)

For details on programming Netcruzer boards, click here.

What is included

This product consists of 2 small boards and a ribbon cable, as shown in the pictures above. Only the cable with two small boards on either end is included, and not any other items shown in the pictures above!